46 deg top cut, then into a radius chamber cut. 65 deg bottom cut.Can you share what top cut angle you used with the 50 deg seat?
Super stock iron heads - work in progress
Moderator: Team
-
KnightEngines
- Guru
- Posts: 2690
- Joined: Fri Jan 09, 2009 8:51 pm
- Location: Australia
Re: Super stock iron heads - work in progress
Re: Super stock iron heads - work in progress
very clean work makes me miss grinding!!
Guy on corvetteforum in the C3 tech needs some heads from you . In your neck of the woods
Guy on corvetteforum in the C3 tech needs some heads from you . In your neck of the woods
Re: Super stock iron heads - work in progress
Nice work Tony, they should go nicely on a MS engine 
Alan Jones
It's Ok to disagree, just don't be disagreeable!
It's Ok to disagree, just don't be disagreeable!