valve guide work
Moderator: Team
-
- Guru
- Posts: 2802
- Joined: Thu Mar 06, 2014 11:55 pm
- Location:
Re: valve guide work
Oversize stems are necked down to standard at the keeper area. No special consideration is needed for keeper or retainer fit.
Agree with eliminating the problem when I run into it. No sense in passing along a headache to the next guy who happens to work on it.
Agree with eliminating the problem when I run into it. No sense in passing along a headache to the next guy who happens to work on it.
Monty Frerichs
B&M Machine
B&M Machine
-
- Guru
- Posts: 4576
- Joined: Sat Mar 26, 2011 11:34 am
- Location: Belgium - Koersel
Re: valve guide work
Way back years ago, before I knew better, I had my virgin big valve -461 real fuelie heads knurled.
Wished I hadn't done it.
I took them in to get a valve job done and told the guy that they were fuelie heads and you know the look that I got from him, "Like sure"!
Went to pick them up and he said, "Right, they are real fuelie heads!"... Take good care of them because I have never seen a real pair before...
pdq67
Wished I hadn't done it.
I took them in to get a valve job done and told the guy that they were fuelie heads and you know the look that I got from him, "Like sure"!
Went to pick them up and he said, "Right, they are real fuelie heads!"... Take good care of them because I have never seen a real pair before...
pdq67