Change 4.3 Chevy V6 balance shaft brgs WO pulling intake? ( does a special tool exist ? )
I know the bearings are cfhangeable if the intake is pulled as the bal shaft is above the cam.
Also, what tends to wear on these, the shaft or bearings? I'd be tempted to install a new shaft on the old bearings ( car lot fix )
Change 4.3 Chevy V6 balance shaft brgs WO pulling intake?
Moderator: Team
-
- Expert
- Posts: 571
- Joined: Fri Dec 01, 2006 5:25 pm
- Location:
-
- Guru
- Posts: 2151
- Joined: Fri Apr 07, 2006 8:23 pm
- Location:
-
- Expert
- Posts: 571
- Joined: Fri Dec 01, 2006 5:25 pm
- Location:
Thanks for the info. I will likely do something to stop the bal shaft from spinning. I know the gear behind the cam gear is there to space it out, the bal shaft gear might be needed to prevent the bal shaft from moving rearward. But, since it isn't spinning it might be OK ( unless it uncovers a oil passage )
Also, in the past I had one of these break all 3 cam bolts causing much noise, poor running.
Also, in the past I had one of these break all 3 cam bolts causing much noise, poor running.