Mill vise project

Post photos/videos of anything* you own - Or, ask to see something.

Moderator: Team

Post Reply
Zmechanic
Pro
Pro
Posts: 408
Joined: Wed Oct 24, 2012 9:33 am
Location: Austin, TX

Mill vise project

Post by Zmechanic » Mon Oct 15, 2018 2:08 pm

Bought this mill vise for cheap. It's an older import. Decided to do a little reconditioning on it. Just finished hand scraping the base. You can see how flat they are from the factory... :shock:

Just starting. The blue is where it's touching the surface plate. This was after the first few early early passes. The very first pass, it was really only touching at the mounting bosses (not too surprising honestly).
20180805_194724.png

After roughing for awhile (trying to start scraping in points but had to go back to roughing).
20180824_205719.png

Done as I'm gonna get it. Still a few low spots, but much improved.
20181014_162617.png
20181014_162750.png
You do not have the required permissions to view the files attached to this post.

n2xlr8n
Expert
Expert
Posts: 545
Joined: Tue Jun 28, 2005 9:01 pm
Location: Bama

Re: Mill vise project

Post by n2xlr8n » Wed Oct 17, 2018 6:38 am

Very nice work.

Probably better than some of the used "high end" mill vises we purchase.
He who is in me is greater than he who is in the world.

Post Reply