Hex head driver and tip holders
Posted: Wed Jun 06, 2018 7:16 pm
Does anyone have any of Ricardos .375 hex head drivers and tip holders
Thanks
Bigblock
Thanks
Bigblock
Don Terrill’s Speed-Talk
Home of Racing's Best and Brightest
https://www.speed-talk.com/forum/
Hex head driver and tip holders
Page 1 of 1
Re: Hex head driver and tip holders
Posted: Mon Jun 18, 2018 7:28 pm
He is very slow at responding and I gave up and just bought some Newen tip holders. I was lucky enough to buy two hex heads from him like 7-8mos ago. Waited for him to make more tip holders but my patience ran low so I gave up.
Re: Hex head driver and tip holders
Posted: Mon Jun 18, 2018 11:34 pm
Thats to bad, I like the tools he made. Wonder what's up with Him.
Re: Hex head driver and tip holders
Posted: Tue Jun 19, 2018 12:01 am
I emailed him and he said he has no help in his shop and concentrates on his 3angle cutters
Shame because I like his stuff and really want another hex drive
Bigblock57
Shame because I like his stuff and really want another hex drive
Bigblock57
Re: Hex head driver and tip holders
Posted: Tue Jun 19, 2018 3:32 am
I use his multiblade system and like it a lot. Bought his hex heads hoping he would make more tip holders but waiting 7-8mos for that to happen was not worth it. I'll eventually get his tip holders when he do have more in stock. Sucks because I really wanted to give his tip holders a try...
Re: Hex head driver and tip holders
Posted: Thu Jun 21, 2018 6:30 pm
Just a heads up on his tip holders while I am sure you know they have different rake angles available Newan will also make cutters with extra rake up to 12 degrees.elvislee1987 wrote: ↑Tue Jun 19, 2018 3:32 am I use his multiblade system and like it a lot. Bought his hex heads hoping he would make more tip holders but waiting 7-8mos for that to happen was not worth it. I'll eventually get his tip holders when he do have more in stock. Sucks because I really wanted to give his tip holders a try...
I have used them and they work just as well as Ricardo's tip holders
Re: Hex head driver and tip holders
Posted: Thu Jun 21, 2018 6:38 pm
The tip holders are not really the problem it was more the extra hex drivers I wanted as I only bought 1 to try the system and now I want another 2 so I can have different cutters set up
Bigblock
Bigblock