Van Norman 944S bar with rollover stand

[MotionMachine]

I've had this bar since 1980, used it until it was replaced by a Kwikway a few years later. It was delegated to small cylinders that the KW could not do so it's had little use in the past 30 years. At some point in the past I did have the motor professionally rewound. I just dug it out and bored a SBC cylinder with it, no taper, smooth as glass. Complete tool kit, no missing parts, comes with the rollover stand that accommodates most any V8. I will crate it for free but you arrange the shipping if needed, otherwise come try it and take it home. Located in Danville VA. $1,500 firm. 434-799-2604.

IMG_2166 (Small).JPG

IMG_2170 (Small).JPG

IMG_2167 (Small).JPG