RMC70 cap grinder for sale

[MotionMachine]

IMG_2132 (Small).JPG

IMG_2131 (Small).JPG

I love this grinder. Tilting table lets you cut any cap regardless of the squareness of the sides. Built for main caps but it will do any cap or rod by simply placing a parallel on the front mounting face and cranking the wheel out father. Great for those rods that are not square to the cheek, like SBF and big Mopars, and even the occasional SBC. The best part is that you can visually scratch test a cap (unlike the Sunnen) and adjust the table with the 2 wing bolts, or install the lock pin for 90 degree cuts. I am only selling because my local equipment had the same grinder in white that I just had to have. 220 3 phase with a twist-lock electrical plug. $1,695 OBO. Needs to truck ship or pick it up, I will crate for free. Danville, VA.