Manton Series 5 Pushrods - New 7/16” Single Taper 7.900” (16)

NOT ALLOWED: Selling or reselling in a retail manner.

Moderator: Team

Post Reply
Jeff Lee
Pro
Pro
Posts: 444
Joined: Sun Jun 26, 2011 1:20 am
Location: Anthem / Phoenix Arizona

Manton Series 5 Pushrods - New 7/16” Single Taper 7.900” (16)

Post by Jeff Lee »

My bad..your gain! 7/16” will not adequately clear the button head screw for link bar attachment.
This is Ball / Ball ends. Pushrod oiling. .168” wall thickness. Not tool steel tips. Single taper (7/16” to 3/8”).
Bought last week for $500.00 plus shipping. Will sell for $335 + actual shipping.
JeffLeeAzRealty@gmail.com or 6oh two-418-9797

From Manton:
Series 5
• High to Extreme Performance
• Non-guide plate use
• Mainly used in Cup, Top Fuel, Pro Modified, Blown Alcohol, Pulling Tractor, Sprint Car, Offshore Marine, and LS Series
• Normally Aspirated, Blown, Turbo Charged or Nitrous
In our series 5 we use a proprietary heat treating process to increase the material value to a Rockwell of approximately 46 “C”. This is critical to the function of a pushrod column and 4130/4135 is very tough, forgiving and durable when used at approximately 46 Rockwell “C”.
In our estimation the only reason to ever produce a one piece pushrod would be because of the reduced cost to manufacture. We are here to produce the highest quality pushrods available and for the reasons listed here we DO NOT manufacture one piece pushrods.
NHRA SS/G
1970 AMC AMX - 390 4-speed
Advanced Clutches - Red Line Racing Cams
Post Reply