Cleaning out the shops

[CNC BLOCKS]

One GM steel crank 1182 magged and turned 010/010 495.00

454 block 2 bolt main block cleaned and magged , Cam tunnel has been indexed .010 over, Line honed with studs, std. deck and bored sonic tested as is 700.00

New GM Hot cam P/N 19210723 specs are 222/230, .509/.528 112 LS 275.00

New Dart cylinder heads P/N 127222 180CC runners 72CC chambers 2.020 X 1.600 1.437 springs 995.00

ALL BLOCKS ARE SEMI FINISHED ARE SOLD AS IS.

Block and crank kit 3731548 Date code of L146 this block has no side motor mounts std. bore and deck has been cleaned and magged and will go to a 4.000 bore but will have to move a few cylinder is the proper direction, Crank is a brand new GM 283 steel crank 3.000 stroke, Pistons are 11:01 TRW for a 4.000 bore with small journal rods all hung with rings, This package would make a nice 302 small block. 1500.00

Two 010 blocks cleaned and mag, sonic tested, one is decked to 9.000 other is 8.990, rough bored to 4.025, 3 center billet splayed caps, stud kit, Line bored and line honed, pan rails have been clearance for a 3.750 stroke, BBC cam tunnel, .8755 lifter bores, as is needs to be finished honed. 1695.00 each

Two Dart SHP Pro blocks 9.000 decks one is a 3.995 bore other is a 4.120 bore cam tunnels are 2.282 Blocks need to be finished honed, lifter bores sized ETC and are sold as is 2295.00

Two Big-M Sportsman blocks 4.490 bores, cam tunnel is machined to 2.282 Lifter bores are .904 and need to be finished to the proper size for lifters being used decked 9.780 sold as is 2295.00

All items are sold as is plus the ride.

[CNC BLOCKS]

I forgot to say the Dart Big-M blocks were short decks and both are sold.

Thanks for looking.
Carl

[CNC BLOCKS]

Both Pro Blocks have been sold should make good asphalt tour Modified engines.

Thanks for looking
Carl

[CNC BLOCKS]

The 010 block with the 8.990 deck has been sold.

Thanks for looking
Carl

[CNC BLOCKS]

The other 010 has now been sold.

Thanks 4 looking
Carl

[CNC BLOCKS]

GM Hot cam is gone.

Thanks for looking
Carl

[CNC BLOCKS]

Dart Heads have been sold !!

Thanks for looking
Carl

[CNC BLOCKS]

Looks like the block and crank kit maybe headed down the road.

Thanks for looking
Carl