RHS Heads wanted

[ProPower engines]

Looking for BARE RHS 12402 torquer type heads With 67cc chambers
I am looking for new unused heads that someone may still have on the shelf

PM me the details
Dave

[rick7343]

Thought you already had them all...??

Arw the dart SS any good? We can run them now.. (wish I new that last seaon...)

[ProPower engines]

Yes I had what was left but they have been flying out the door as fast as I could build them.
I need a pair of 67cc heads for a spec engine. I could use the World head but prefer not to.

[ProPower engines]

Still lookin if anyone has a pair or single head/s they are not using.

[bigjoe1]

I have two heads that might be what you are looking for. I will check them out ASAP, and get back to you..


JOE SHERMAN RACING

[rick7343]

Which are better, RHS or Dart? ( 165-176 runner, 1.94/1.5 valve stock replacements)

[ProPower engines]

Which are better, RHS or Dart? ( 165-176 runner, 1.94/1.5 valve stock replacements)

The RHS head flows better then the dart as cast by a good margin.
They are just exstinct not. I talked to EQ and they are going to produce the heads in the new year so they say. They did not give a date. They also did not indicate if the casting quality would be the same as the RHS was.
The Dart S/R head is almost as good but with a decent valve job they are within 1% of the RHS head.
They are better at one point but not as good as another .
After .500 they drop off much more then the RHS as cast

[justahoby]

Which are better, RHS or Dart? ( 165-176 runner, 1.94/1.5 valve stock replacements)

The RHS head flows better then the dart as cast by a good margin.
They are just exstinct not. I talked to EQ and they are going to produce the heads in the new year so they say. They did not give a date. They also did not indicate if the casting quality would be the same as the RHS was.
The Dart S/R head is almost as good but with a decent valve job they are within 1% of the RHS head.
They are better at one point but not as good as another .
After .500 they drop off much more then the RHS as cast

I ran a set of 180 iron rhs heads on my 383 74cc light porting as they were cast great as is.. Good stinking heads for the money,
Just a little bit of hell with rockers and geometry, but I would do it again ! Looking for a set for a tow and go 400 sbc

[rapidride2]

Not 12402 but I have a set of 12410 with 2.02 1.60 valves. This is the fully assembled head.

[ProPower engines]

Still looking if anyone has some in the corner collecting dust