Page 2 of 2

Re: Ball joint question

Posted: Sat Mar 14, 2015 5:11 pm
by pdq67
Off topic!

Looking at the big 1st Gen "A-Arms and Spindle" picture, what dimensions do I need to measure so that I can calculate my front roll center height?? (Plus need the front roll center formula to do so).

I have Pro-Motorsports 2-15/16" tall spindle extenders on my car as well as a bottom "1/4 coil clock-cut" and one complete bottom coil cut off of new 5536 coil springs.

And if needed, my sway-bar is parallel with the floor.

Thanks for putting up with me..

pdq67