bump steer kit

Shocks, Springs, Brakes, Frame, Body Work, etc

Moderator: Team

Ron Gusack
Expert
Expert
Posts: 668
Joined: Sat Dec 22, 2007 11:42 pm
Location: Maryland

bump steer kit

Postby Ron Gusack » Thu Aug 28, 2014 12:48 pm

I put a bump steer kit on my 70 Nova and the alignment guy adjusted it as close to the steering knuckle as he could but said it needed to be even closer. He said a stock tie rod end would be better for my car. Anybody run into this situation before?
The things you see when you ain't got your gun!

User avatar
MadBill
Guru
Guru
Posts: 12412
Joined: Tue Nov 15, 2005 10:41 am
Location: The Great White North

Re: bump steer kit

Postby MadBill » Fri Sep 05, 2014 10:07 pm

A typical bump steer kit can only move the pivot point in one direction (usually down), which may or may not be what's required. Moving the inboard end of the tie rod down does the same thing as moving the outer end up, so if the kit will fit at the inboard end, just use it there.

Not that I recommend it, but I've seen a big hammer used to 'adjust' the height of the steering arm... :roll:
Here's a useful link from another S/T thread: http://www.pozziracing.com/
Felix, qui potuit rerum cognscere causas.

Happy is he who can discover the cause of things.

justahoby
Guru
Guru
Posts: 1172
Joined: Sat Oct 22, 2011 12:28 am
Location: Temporarily in Stephenville, Texas, USA from Thunder Bay, Canada
Contact:

Re: bump steer kit

Postby justahoby » Wed Sep 10, 2014 12:44 pm

I had a bump steer issue in my truck with different spindles,and it was very annoying chirping of tires over railroad tracks and stuff. When I lowered it with springs it went away with the angles changing with the lower A frame and tie rod. Also I made my tie rods more even to help eliminate some...It took a long time to figure out what was better.
As I'm approaching 40,I still think I'm 20. What the hell is wrong with me?

HotRodRay
New Member
New Member
Posts: 23
Joined: Tue Aug 15, 2017 11:29 pm

Re: bump steer kit

Postby HotRodRay » Tue Sep 12, 2017 8:13 pm

Guessing wont work. Which is what happens when you duplicate somebody elses changes.

There is really no substitute for actually measuring one front wheel, and adjusting as necessary. (Both should be identical)

It is not tough, but takes a little understanding as to how its done.


Return to “Chassis / Suspension / Body”

Who is online

Users browsing this forum: peejay and 1 guest