Final Results For The Race Engine Challenge

General engine tech -- Drag Racing to Circle Track

Moderator: Team

Steve.k
Expert
Expert
Posts: 829
Joined: Sat May 28, 2016 10:41 am

Re: Final Results For The Race Engine Challenge

Post by Steve.k » Sun Oct 07, 2018 1:52 pm

Thanks. Mike. Good news.Is c3 allowed in inline?I guess newer c3 they took cant out.

Walter R. Malik
Guru
Guru
Posts: 4062
Joined: Tue Jul 24, 2012 11:15 am
Location: Roseville, Michigan (just north of Detroit)
Contact:

Re: Final Results For The Race Engine Challenge

Post by Walter R. Malik » Sun Oct 07, 2018 8:10 pm

Steve.k wrote:
Sat Oct 06, 2018 8:27 pm
Congratulations to Greg and Hammerhead. Also to Walter who was right in there. I talked to walter before event and 383 was 726@7200. So not sure what he had there.
With the compression ratio a TENTH of a point to high on one side it had 752 @7,100 and 606 tq @5,700
http://www.rmcompetition.com
Specialty engine building at its finest.

Steve.k
Expert
Expert
Posts: 829
Joined: Sat May 28, 2016 10:41 am

Re: Final Results For The Race Engine Challenge

Post by Steve.k » Sun Oct 07, 2018 8:29 pm

1/10? Ha that seems a little tight on measurements i say!Could be a error in math that close.

Post Reply