What set of SBC 6.0 rods has the best cam clearance for 383

[Mark O'Neal]

Horsepower ratings are based on the fact that y'all keep asking........

I rate one rod at 500 HP. I've run it at 1725, with an 8740 bolt.

We just don't want to get sued any more often than is absolutely necessary.

[MadBill]

Sort of like you buy a claw hammer and find a label on it that reads: "Caution. May contain nuts or nut products." (Yes, the handle might be hickory...) Ya can't be too careful in retail sales.

[af2]

Sort of like you buy a claw hammer and find a label on it that reads: "Caution. May contain nuts or nut products." (Yes, the handle might be hickory...) Ya can't be too careful in retail sales.

Bill!!!
I am having a hard time buying parts for the race car in California because of prop 65!!! May contain styrine!!! Like I'm going to smoke it?

[af2]

Back to the OP... I used the Scat PC rods with the LT4 cam and had to relieve .060" on 2 rods. Was not a big deal.

[rfoll]

Compstar 6" rods with a 3.875 crank hit my .425 lobe standard base circle. I've seen others on this forum complain that they don't clear as much as advertised.