WHICH BRONZE & WHAT PRESS FIT FOR ROD BUSHING
Posted: Thu Jun 07, 2018 10:12 pm
I'm working an an air cooled single cylinder 250 cc triumph and need to make a bronze bushing for the rod for the floating piston pin. I'm guessing it will probably see around 350 degrees. The id of the rod is around .700 and the thickness of the bushing is .047.
Which bronze would be best to use?
How much interference fit for the bushing/rod?
Thanks for any help.
Which bronze would be best to use?
How much interference fit for the bushing/rod?
Thanks for any help.