Flow bench results

General engine tech -- Drag Racing to Circle Track

Moderator: Team

Post Reply
statsystems
Guru
Guru
Posts: 1518
Joined: Sun Apr 03, 2016 1:17 am

Re: Flow bench results

Post by statsystems » Sun Jun 10, 2018 2:24 pm

John Wallace wrote:
Sun Jun 10, 2018 1:46 pm
So a head that flowzz 415 cfm is a lot better than a head that flowz 415 cfm?
(and a lot better than one that flows 415 cfm)

:?:

Should make a sticky out of this post.

Sums it up perfectly.

Rick360
Guru
Guru
Posts: 1043
Joined: Sun Oct 03, 2004 9:55 pm
Location: Missouri

Re: Flow bench results

Post by Rick360 » Sun Jun 10, 2018 2:51 pm

statsystems wrote:
Sun Jun 10, 2018 2:24 pm
John Wallace wrote:
Sun Jun 10, 2018 1:46 pm
So a head that flowzz 415 cfm is a lot better than a head that flowz 415 cfm?
(and a lot better than one that flows 415 cfm)

:?:

Should make a sticky out of this post.

Sums it up perfectly.
But a head that flowZZ 415 cfm makes even MORE power than one that only flowzz 415 cfm. =D>

So to sum it up ...
flowZZ > flowzz > flowZ > flowz > flows

Rick

swampbuggy
Expert
Expert
Posts: 763
Joined: Mon Apr 04, 2011 8:54 pm
Location: central Florida

Re: Flow bench results

Post by swampbuggy » Sun Jun 10, 2018 3:10 pm

Flows=461 196?
FLOWZZ= DRCE Pro-stock. 2018. LOL. Mark H.

GARY C
Guru
Guru
Posts: 4653
Joined: Tue May 14, 2013 10:58 pm

Re: Flow bench results

Post by GARY C » Sun Jun 10, 2018 3:57 pm

swampbuggy wrote:
Sun Jun 10, 2018 7:08 am
Gary, Matt who is MBE cylinder heads said that they got away from taper in the port and there's more power there with less taper this is on high horsepower stuff. Mark H.
On a better designed induction system you have more control of size shape and cs consistency, my comment was toward as cast 23 degree components. On a single depending on rpm and application you have between 3 and 3.5 sq in at the plenum tapering down to 2 sq in at the flange where a RPM Airgap is near 2 sq in from plenum to flange, on a street vs race tunnel ram you would see a size, length or taper difference.
Please Note!
THE ABOVE POST IN NO WAY REFLECTS THE VIEWS OF SPEED TALK OR IT'S MEMBER AND SHOULD BE VIEWED AS ENTERTAINMENT ONLY...Thanks, The Management!

midnightbluS10
Pro
Pro
Posts: 440
Joined: Sun Oct 20, 2013 8:41 am

Re: Flow bench results

Post by midnightbluS10 » Mon Jun 11, 2018 1:18 pm

RevTheory wrote:
Sun Jun 10, 2018 9:13 am
It's just a long-running funny that Randy came up with a year or two ago. It stuck :lol:
Thank you! I thought I was losing my mind. Or you guys were lol.

Post Reply