BBF shaft rockers
Moderator: Team
BBF shaft rockers
Looking at options for A460 heads on a Bbf. 800+ lift 9000rpm 470" puller. Aluminum or ss? Ratio? Had T&D in mind but??? Thanks!
-
- Guru
- Posts: 6386
- Joined: Tue Jul 24, 2012 11:15 am
- Location: Roseville, Michigan (just north of Detroit)
- Contact:
Re: BBF shaft rockers
Personally, on those heads I would use W W Engineering.
http://www.rmcompetition.com
Specialty engine building at its finest.
Specialty engine building at its finest.
-
- Guru
- Posts: 1037
- Joined: Sun Jul 05, 2015 6:01 pm
- Location:
Re: BBF shaft rockers
The T&D don't clear big springs. Don't understand how they can't figure out guys will be running 1.625-1.660 springs on these.
Re: BBF shaft rockers
I have used them in another application with good results. Any ratio advice? 1.75 or 1.8? ThanksWalter R. Malik wrote: ↑Sun Jan 21, 2018 10:30 amPersonally, on those heads I would use W W Engineering.
Re: BBF shaft rockers
That would definitely be a problem. Thanks for the info !Frankshaft wrote: ↑Sun Jan 21, 2018 11:25 am The T&D don't clear big springs. Don't understand how they can't figure out guys will be running 1.625-1.660 springs on these.