It was only the middle top part of the cap to be worn, so i then decided to remove the head to line hone it, thanksDavid Redszus wrote:For a 1.0" cam journal, a bearing clearance of .0014" to .0032" is quite normal. You did not indicate a measure for out of roundness. Typical roundness spec might be .0012".John@RED wrote:Newold1 wrote:If taking only (.0007") 7 hundred thousandths will get you back in the cam journal to bore clearance range, I would go for it as that small amount is not going to oval the 1" bores enough to make a real issue in my opinion. I would guess stock new clearances there are probably .002" or so to start with.
Thanks. Stock range is 0.0010 to 0.0024 so imho it is already pretty large for a 1.063 diameter cam, that's why I'd like to return at least in range
Which part of the cam bearing cap is worn?
Reduce cams clearance
Moderator: Team