350 stock steel rocker arm lift
Moderator: Team
-
- Member
- Posts: 144
- Joined: Sat Feb 09, 2013 7:58 pm
- Location:
350 stock steel rocker arm lift
im putting a 270 magnum which is 480 lift. will a stock rocker arm handle this as far as the slot not binding up?
-
- Member
- Posts: 144
- Joined: Sat Feb 09, 2013 7:58 pm
- Location:
-
- Guru
- Posts: 1747
- Joined: Tue Jan 15, 2013 8:10 pm
- Location:
Re: 350 stock steel rocker arm lift
I didn't keep the precision tool I last used to check for rocker-to-stud clearance.
A strategically bent paper clip, as I recall recommended by the late, great Racer Brown.
A strategically bent paper clip, as I recall recommended by the late, great Racer Brown.
-
- Member
- Posts: 144
- Joined: Sat Feb 09, 2013 7:58 pm
- Location:
Re: 350 stock steel rocker arm lift
its a hydraulic cam, maybe ill throw a solid ifter in one hole and check it out, as I don't have the intake on yet...... or probably a paper clip either...lol
-
- Guru
- Posts: 2802
- Joined: Thu Mar 06, 2014 11:55 pm
- Location:
Re: 350 stock steel rocker arm lift
I always used a piece of wire solder and you can measure the clearance after the rocker cuts in to the solderDan Timberlake wrote:I didn't keep the precision tool I last used to check for rocker-to-stud clearance.
A strategically bent paper clip, as I recall recommended by the late, great Racer Brown.
Re: 350 stock steel rocker arm lift
Off topic....
And don't forget the "Louis/Slotting Tool" if you want to install 1.6 ratio rockers..
pdq67
And don't forget the "Louis/Slotting Tool" if you want to install 1.6 ratio rockers..
pdq67