Also curious how this will turn out. A buddy has a 4.625" Dart Big M that I refused to do. Appeared two head bolt holes would be too close to the sleeve. Figured there would be a good chance for cracking or distortion when torque plating.
Think normal sleeving practice of sitting the bottom on a 90 degree ledge would prevent slippage.
Multiple repair sleeves on big bore Dart Big M BBC
Moderator: Team
Re: Multiple repair sleeves on big bore Dart Big M BBC
if the bottom is not doable without a lot of work
or
I just like the top flange better
good materiel
thick
should work
or
I just like the top flange better
good materiel
thick
should work