jesel alignment

bsfc9 · Post by **bsfc9** » Sun Jul 25, 2004 9:53 am

has anyone noticed that on some jesel setups(particuarly 23 degree chev)the roller does not center on the valve tip(when viewing from the side of the engine). it seems some of the rollers will be centered pretty good, but others will not. now, our geometry is correct, good sweep pattern on the valve tip, correct stand installation, etc. i know jesel makes spacers to adjust this but ther seems to be no room for them on some, short of putting in a more narrow bearing. sorry for being long-winded hope this describes clearly. hey don how about an interview with some one from Jesel.

STOCK 1090 · Post by **STOCK 1090** » Sun Jul 25, 2004 10:36 am

BSFC9,
I don't know your answer, but here is the guy who can help from Jesel.
Try Steve Kutch at 732-901-1800 ext 120

Rich

bsfc9 · Post by **bsfc9** » Sun Jul 25, 2004 9:29 pm

thanks rich, appreciate the contact info!