Don Terrill’s Speed-Talk

well just put a new pump and pick up on and it fix the problem i also have the hv pump thank for every ones help

no it has about 3/8 from the pan on start up it now goes to 45 psi when u rev it it goes to 60 psi then at about 2k rpm it drops to about 40 psi any higher it goes to about 30 psi and holds there do u think the pump is bypassing to early

well just put some vr 40wt in it and it idles at 40psi and when i rev it the oil pressure drops what is going on with this

I have a 421sbc dart lil m block millings 55hv oil pump I am using val 10/30 oil just got the motor together at idle it was holding about 50-60 psi and went to 85-95 psi when I revved it up. here is where the problem starts I made about 2 1/8 mil passes after the second pass the pressure was at 20 p...

what about howards billet rods are they any good for my combo

dfree383 wrote:I would think an Aluminum Rod would be easier on everything at that HP and RPM level, I'd shy away from steel rods IMO

GRP, Groden, Ect.

so y are aluminum rods easier on everything and y not a steel also what brand of aluminum rod will clear 3.875 stroke and std. cam

i will be sprying 350 shot to it

i have a sbc 421 3.875 stroke and 6"rod i sling to 8100rpm it made 1063hp i was wondering what is going to be the best rods for this

can my crank be cut down to a Honda Journal

i have the cooling holes in the block. would a GRP rod clear the std. cam on a dart little m block with a 3.875 stroke

im going to just repair the crank but now i need some good rods i am thinking about the howards billet rods or the compstars

i have a 421 sbc with sb2 heads i sling it to 8100rpm and i have eagle h beam rods with l19 bolts and eagle 4340 crank well to say the least one of the rods broke in half the motor made 1063 hp on the 300 shot so i need some thing to hold that . now i am tryn to decide what crank and rods to get i a...

i have a ls1 smog pump and it pulls 6 lbs i just took the fome and solinoid out and resealed it and it works great

i still have one

that is the same lifters i am using on my dart sb2.2 headed 421